Two channel switch & controller RST2X7A.

Two channel switch-controller RST2X7A is designed to control two independent loads (motors, LEDs, siren, light bulbs, etc.) by two channels of radio control system. Each channel can be operated as a controller or switch.

PWM maximum limit of the controller can be set to any value between 0 and 100 %.

The switch output can only be switched on and off or there can be set sequence of repeated switch-on and switch-off of the output by up to 20 sections. The duration of each segment can be set from 100 ms up to 5.1 seconds with a step of 100 ms. You can easily set the flashing lights 1:1 for model of car as to generate a sequence of SOS (... - - -...) for a ship model.

The switch in case of loss of signal from the receiver begin to generate the replacement of pulses that can be preset.

Control circuit of the switch-controller is powered from the receiver (3.5 to 6 V), load in the two channels can be supplied with voltage from 0.5 to 16 V. The maximum output current in both channels can be up to 7 A. Dimmension are 32 x 15 x 5 mm and weight 14 g.

Examples of using:
- for control of right and left turn signals in the car, connecting the two input switches in parallel to steering servo
- step-less speed controlling in the twin models of ships, aircraft or tracked vehicles
- as two-channel flasher (without control with radio system)